02

2011

-

06

The Relationship Between Wear-Resistant Steel Ball Size and Grinding

Author:


When the mill rotational speed and filling ratio are held constant—i.e., when the motion state of the grinding media is fixed—the size of the wear-resistant steel balls significantly influences the particle-size distribution, liberation degree, and consumption metrics of the milled product.

When the mill rotational speed and filling ratio are held constant—i.e., when the motion state of the grinding media is fixed—the size of the wear-resistant steel balls significantly influences the particle-size distribution, liberation degree, and consumption metrics of the milled product. Specifically, this effect manifests in the following six key aspects:

(1) Mill productivity. When the ball diameter is too large, reduced impact frequency and a smaller grinding surface area lead to lower productivity. Conversely, when the ball diameter is too small, insufficient impact force also results in reduced productivity. Precisely optimizing the ball diameter can significantly increase mill productivity.

(2) Uniformity of the particle-size distribution of the milled product. An excessively large ball diameter results in fewer impacts, leading to a higher proportion of coarse particles that are not sufficiently ground; moreover, excessive impact force increases the degree of over-grinding. Consequently, when the ball diameter is too large, the product exhibits an uneven particle-size distribution, with both overly coarse and over-ground fractions being abundant, which is detrimental to mineral separation.

(3) The degree of monomeric liberation of minerals in the grinding product. An excessively large ball diameter, due to excessive impact force, leads to through-breaking of the ore, resulting merely in a mechanical reduction in particle size without achieving high mineral monomeric liberation. When the ball diameter is optimized, the probability of mineral liberation along cleavage planes increases, thereby enhancing the degree of monomeric liberation in the product.

(4) The level of grinding media consumption. According to Davis’s theory of steel ball wear, the wear rate of the balls is directly proportional to their weight: larger balls wear more rapidly and consume more media, while smaller balls wear more slowly and consume less.

(5) Power consumption. When the ball charge remains constant, smaller balls consume less power than larger balls.

(6) The magnitude of noise generated during mill operation. Larger grinding balls, owing to their greater kinetic energy, experience greater sound-energy loss upon mutual impacts or when striking the mill liners, resulting in higher noise levels. Precisely controlling the ball diameter can help reduce noise.